Tricity Bendix TBE635WH Instrukcja Użytkownika Pobierz pdf (Strona 10)

Electrical connections

Any electrical work required to install this hob

should be carried out by a qualified electrician or

competent person, in accordance with the current

regulations.

THIS HOB MUST BE EARTHED.

The manufacturer declines any liability should these

safety measures not be observed.

This hob is designed to be connected to a 230V 50Hz AC

electrical supply.

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the hob rating

plate. The rating plate is located on the bottom of the

hob. A copy is attached on the back cover of this book.

The hob is supplied without supply cord. A 3 core flexible

supply cord must be fitted, in accordance with the

specification given in the relevant tables.



20 min

FO 1013

Dimensions are given in mm.

Building over a kitchen unit

with door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the bottom

of the hob which can be hot when in operation. The

recommended solution is shown in diagram 3.

The panel fitted under the hob ("a") should be easily

removable to allow easy access if technical assistance

is needed. The space behind the kitchen unit ("b") can

be used for connections.

FO 0199

Fitting the Hob into the worktop

Carry out the building in of the hob as follows:

• put the seals supplied with the hob, on the

edges of the cut out: place them exactly on

the front and rear edge and at 50 mm. from the

side edges, taking care that the seals meet

without overlapping;

• place the hob in the cut out, taking care that it

is centred;

• fix the hob with the relevant fixing clamps and

screws, as shown in the diagram. When the

screws have been tightened, the excess seal

can be removed.

The edge of the hob forms a double seal which prevents

the ingress of liquids.

a) Sealing gasket



1) Remove the mains terminal cover plate from the

underside of the hob, to expose the mains terminal

block.

2) Loosen the two cable clamp screws and lift the top

section of the clamp enough to allow the cable to

be passed through.

3) Connect the red (live) wire to the terminal which is

marked with the number 1.

4) Connect the black (neutral) wire to the terminal

which is marked with the number 4.

5) After fitting a green or yellow/green sleeve over the

bare copper wire (earth wire), connect the exposed

end to the terminal which is marked with the earth

symbol or with the number 5.

NOTE:

The earth wire should be about 2 cm. longer than

the live and neutral wires.

6) Secure the cable by means of the clamp screws

and refit the terminal block cover.

1 2 ... 5 6 7 8 9 10 11 12

Komentarze do niniejszej Instrukcji

Brak uwag

Tricity Bendix TBE635WH Instrukcja Użytkownika Strona 10

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Płyty grzewcze Tricity Bendix TBE635WH