Tricity-bendix SIE 252 Instrukcja Użytkownika Strona 8
- Strona / 28
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
8
WARNING: THIS APPLIANCE MUST BE EARTHED
RATING PLATE
This is situated on the lower front frame of the
appliance and can be seen upon opening the door.
Alternatively the rating plate may also be found on
the back or top of some models (where applicable).
The appliance must be protected by a suitably rated
fuse or circuit breaker. The rating of the appliance is
given on the rating plate.
Do not remove the rating plate from the appliance
as this may invalidate the guarantee.
INSTALLATION
If your appliance has been damaged in transit,
contact your supplier immediately. DO NOT attempt
to install it.
Your appliance left the factory fully packaged to
protect it from damage. If it is delivered without
packaging and damage has occurred, the
manufacturer cannot accept responsibility. Contact
your supplier for advice.
Once the packaging has been removed the appliance
should only be moved by hand. DO NOT use a sack
barrow or any other aid to lift the appliance as
damage may occur.
Connection to the electricity supply must be carried
out by a qualified electrician/competent person.
The electrical connection should be made using a
double pole isolating switch (cooker socket) with at
least 3mm contact separation in all poles. The cable
must have conductors of sufficiently high cross-
sectional area to prevent overheating and
deterioration.
The recommended cross-section area is six square
millimetres (6.00mm
2
).
The cable should be routed away from potentially hot
areas marked by X in the diagram below.
To move the appliance, open the oven door, and lift
the appliance by holding inside the top of the
compartment.
This is a type X appliance, which means it is free-
standing and can be fitted with cabinets on one or
both sides. It may also be fitted in a corner setting.
Side walls which are above hob level should be
protected by heat resistant non-combustible material
and MUST NOT be nearer than 40mm to the hob
side.
A nominal air gap of 2mm at the either side of the
appliance is required to enable the appliance to be
moved into position. It is recommended that
proprietary trims are fitted to protect the worktops of
either side of the appliance. These are available
from most DIY stores.
Two spacers have been incorporated into the back of
the appliance to ensure an air gap of 10mm is
maintained at hotplate level. Tiles or other forms of
deep wall covering should not obscure this gap.
INTRODUCTION
10mm gap
- SLIP IN ELECTRIC COOKER 1
- MODEL NO. SIE 252 2
- TECHNICAL DETAILS 2
- CONTENTS 3
- AFTER USE 7
- INTRODUCTION 8
- THE CONTROL PANEL 10
- FEATURES 10
- RECOMMENDED SAUCEPANS 11
- HINTS AND TIPS 11
- DEEP FAT FRYING 12
- PRESERVING 12
- · Close the oven door 13
- THE GRILL 13
- GRILLING CHART 14
- THE FAN OVEN 15
- OVEN COOKING CHART 17
- ROASTING CHART 18
- USES OF DEFROST 19
- SELECTING DEFROST 19
- THINGS TO NOTE 19
- CARE AND CLEANING 20
- INNER DOOR GLASS 22
- TO REPLACE THE OUTER GLASS 22
- TO CLEAN THE INNER GLASS DOOR 22
- SOMETHING NOT WORKING? 23
- SERVICE AND SPARE PARTS 24
- CUSTOMER CARE DEPARTMENT 24
- Standard guarantee conditions 25
- Exclusions 25
- European Guarantee 25
Powiązane produkty i podręczniki dla Płyty grzewcze Tricity-bendix SIE 252
(32 strony)Philips SB4B1928UB/00 manuels
Manuels d'utilisation et guides de l'utilisateur pour Haut-parleurs d'amarrage Philips SB4B1928UB/00.
Nous fournissons des manuels en pdf 1 Philips SB4B1928UB/00 à télécharger gratuitement par type de document : Manuel de l'utilisateur
Komentarze do niniejszej Instrukcji